2003 Subaru Impreza

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Rear Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Headlamp light source and lamp not compatible HID bulbs fitted to standard H7 Headlamp (4.1.4 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp light source and lamp not compatible HID bulbs fitted to standard H7 Headlamp (4.1.4 (c))

Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt ball joint dust cover is split (5.3.4 (b) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit inner edge (4.1.E.1)

Nearside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Nearside Front windscreen damaged

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nail in offside rear tyre

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Stop lamp not working (1.2.1b)

cut to n/s/f tyre outre wall and nail in tyre

front brake pads getting low

small cut to o/s/f tyre outer wall