2007 Peugeot 107

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust emissions likely to be affected by an exhaust leak Before backbox. (8.2.1.1 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside rear wheel bearing not tested.

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear axle beam corroded.

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside rear wheel bearing not tested.

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear axle beam corroded.

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Body component damaged and likely to cause injury bumper (6.2.1 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a minor leak of exhaust gases centre exhaust section (6.1.2 (a))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

NEARSIDE AND OFFSIDE FRONT TYRES ON WEAR INDICATORS REPLACEMENTS RECOMENDED

REARBRAKE SERVICE NEEDED

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust system not adequately supported (7.1.1)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

nearside front brake pads worn low

offside rear brake squeel

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside front brake juddering slightly (3.7.A.2b)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside front brake juddering slightly (3.7.A.2b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside front brake juddering slightly (3.7.A.2b)

Registration plate lamp insecure (1.1.C.1c)

Registration plate lamp not working (1.1.C.1d)