2004 Honda Jazz

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Brake pipe excessively corroded front to back (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Coil spring corroded All 4 (5.3.1 (b) (i))

Front Suspension arm corroded but not seriously weakened Nearside and Offside (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge Slightly worn on both edges,Tread depth at 2.3mm (5.2.3 (e))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement Top mount (5.3.4 (a) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front Tyre worn close to legal limit/worn on edge Slightly worn on both edges , Also slight damage to outer side wall (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge Tread depth at 2.1mm (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. Slightly Imbalanced (1.2.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive Nearside and Offside (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Floor end plate rear end (6.1.1 (c) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened wishbone (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened wishbone (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced floor end plate rear end (6.1.1 (c) (i))

Rear rear axil andrear end of floor surface rusted

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Vehicles internal headlight adjuster altered to recheck lights ()

Front Windscreen washer not working (3.5 (a))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Vehicles internal headlight adjuster altered to recheck lights ()

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Rear Child Seat fitted not allowing full inspection of adult belt ()

slight restriction nearside rear wheel soon requires attension

Front Windscreen washer provides insufficient washer liquid (8.2.3)

slight restriction nearside rear wheel soon requires attension

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)