MOT Status
ExpiredMileage
121,891 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Central Rear Lower Vehicle structure is corroded but structural rigidity is not significantly reduced rear axle (6.1.1 (c) (i))
Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Offside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill covered unable to check welding (6.1.1 (c) (i))
Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))
Offside Rear Child Seat fitted not allowing full inspection of adult belt ()
Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))
Offside Front Position lamp not working (4.2.1 (a) (ii))
Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced Floor to sill centre to front (7.1.1 (a) (i))
Offside Stop lamp(s) not working (4.3.1 (a) (ii))
Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Both sides inner sills (5.3.6 (a) (i))
Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS
Brake pipe corroded, covered in grease or other material All (1.1.11 (c))
Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))
Front Tyre worn close to legal limit/worn on edge Both sides (5.2.3 (e))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
Underside of vehicle is rusty/corroded and hard to access
Headlamp levelling device inoperative (4.1.5 (a))
Horn not working (7.7 (a))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Nearside Rear Service brake excessively binding (1.2.1 (f))
Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))
Front Tyre worn close to legal limit/worn on edge Both sides (5.2.3 (e))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Rear Tyre obviously under inflated (5.2.3 (l))
Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
Underside of vehicle is rusty/corroded and hard to access
Front Tyre worn close to legal limit/worn on edge Both sides (5.2.3 (e))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
inner and outer sills corroded bit not considered excessive
All welding repairs hard to access due to underseal and filler
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Offside Rear Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS
All welding repairs hard to access due to underseal and filler
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Nearside Front Service brake excessively binding (1.2.1 (f))
Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced centre sill (7.1.1 (a) (i))
Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))
Offside Rear Brake pipe excessively corroded front to rear under wheel arch (1.1.11 (c))
Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))
Nearside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))
Offside Front Service brake binding but not excessively (1.2.1 (f))
Brake pipe corroded, covered in grease or other material Both front to rears (1.1.11 (c))
Items removed from driver's view prior to test ()
Seat belt anchorage prescribed area is corroded but not considered excessive Both inner sills full length (7.1.1 (a) (i))
Front Registration plate does not conform to the specified requirements spacing incorrect (0.1 (d))
Horn not working (7.7 (a) (ii))
Parking brake inoperative on one side Both (1.4.1 (a))
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS
Brake pipe corroded, covered in grease or other material Both front to rears (1.1.11 (c))
Items removed from driver's view prior to test ()
Seat belt anchorage prescribed area is corroded but not considered excessive Both inner sills full length (7.1.1 (a) (i))
Under vehicle general corrosion.
Horn not working (7.7 (a) (ii))
Nearside Parking brake inoperative on one side (1.4.1 (a))
Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Offside Front Position lamp not working (4.2.1 (a))
Offside Parking brake inoperative on one side (1.4.1 (a))
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS
Under vehicle general corrosion.
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))
Offside Rear Service brake excessively binding (1.2.1 (f))
Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)
Front Brake pad(s) wearing thin (3.5.1g)
Front Horn not working (1.6.2a)
Front Tyre tread depth below requirements of 1.6mm both sides (4.1.E.1)
Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)
Nearside Front Front position lamp(s) not working (1.1.A.3b)
Front Brake pad(s) wearing thin (3.5.1g)
Horn not working (1.6.2a)
Nearside Front position lamp(s) not working (1.1.A.3b)
Offside Headlamp aim too low (1.8)
Offside Rear Anti-roll bar linkage insecure (2.4.G.1)
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)
Centre Exhaust has a major leak of exhaust gases (7.1.2)
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)
Offside Track rod end ball joint has excessive play (2.2.B.1f)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Steering column top bearing slightly worn (2.1.2c)
air bag waring light illuminated on dash
Direction indicators not working (1.4.A.2c)
Horn not working (1.6.2a)
Nearside Steering locking device missing (2.2.C.1g)
Offside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)
Offside Steering locking device missing (2.2.C.1g)
Offside Stop lamp not working (1.2.1b)
Power steering inoperative (2.3.3a) DANGEROUS
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
air bag waring light illuminated on dash
How Reliable is the Honda Civic?
Based on 9,391,580 MOT tests across 693,715 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
LW04 KBJ is a 2004 Honda Civic in Grey with a 1,998cc petrol engine. This vehicle has been through 30 MOT tests with a personal pass rate of 56.7%.
Across all 2004 Honda Civic models, the average MOT pass rate is 74.2% with a typical mileage of 74,453 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Honda Civic fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 307,913 recorded failures. If you're considering buying LW04 KBJ, it's worth having these areas checked by a mechanic before committing.
The Honda Civic typically stays on UK roads for around 34 years. At 22 years old, this Honda Civic is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of LW04 KBJ?
You can check the full history of LW04 KBJ by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was LW04 KBJ registered?
LW04 KBJ is a 2004 Honda Civic, first registered on 7 August 2004.
Is LW04 KBJ safe to buy?
The MOT history for LW04 KBJ shows 30 tests with a 56.7% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does LW04 KBJ have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on LW04 KBJ. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.