2003 Smart (mcc) Cabriolet

Central Rear Oil leak, but not excessive (8.4.1 (a) (i))

Central Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Central Rear Oil leak, but not excessive (8.4.1 (a) (i))

Central Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge worn on outer edge (5.2.3 (e))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Central Rear Lower Engine mounting damaged or deteriorated resulting in excessive movement dog bone mount torn (6.1.8 (a) (i))

Central Rear Upper Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii))

Front Position lamp adversely affected by the operation of another lamp both front side lights affected by brake peddle (4.2.3 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure exposing cords 175/55/15 (5.2.3 (d) (ii)) DANGEROUS

Rear Stop lamp(s) remains on when the brakes are released all brake lights stuck on (4.3.2 (a) (iii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge worn on outer edge (5.2.3 (e))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge close to wear marks (5.2.3 (e))

Nearside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge close to wear marks (5.2.3 (e))

Offside Front Headlamp aim projected beam image is obviously incorrect bulb incorrect fitment (4.1.2 (c))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge close to legal limit (5.2.3 (e))

Horn not working (7.7 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Hydraulic brake cylinder leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge close to legal limit (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Fuel cap/sealing device component leaking (6.1.3 (b) (i))

Offside Direction indicator incorrect colour (4.4.3 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Horn not working (1.6.2a)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Two small cuts in N/S/F tyre outer sidewall

Front Brake pad(s) wearing thin (3.5.1g)