2005 Audi Tt

Offside Front Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Inner Tyre worn close to legal limit/worn on edge heavily worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush split (5.3.4 (a) (i))

Front Inner Tyre worn close to legal limit/worn on edge NS&OS (5.2.3 (e))

Front Macpherson strut pin or bush worn but not resulting in excessive movement top mounting NS & OS (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge worn to 3mm (5.2.3 (e))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge worn to 3mm (5.2.3 (e))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Exhaust deteriorated

Offside front tyre worn on inner edge

Offside Front tyre worn on inner edge

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Tyre has ply or cords exposed on outer side wall (5.2.3 (d) (ii)) DANGEROUS

Offside Front tyre worn on inner edge

Exhaust deteriorated

Offside front tyre worn inside edge

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Exhaust deteriorated

Offside front tyre worn inside edge

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside rear tyre worn on inside edge.

Odd tyre tread patterns fitted across front axle.

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Offside Front Front position lamp(s) not working (1.1.A.3b)