2011 Mazda MPV

Nearside Front Nail in tyre ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Nail in tyre ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pad(s) wearing thin PADS LOOK LOW BUT UNABLE TO SEE CLEARLY (1.1.13 (a) (ii))

rear arches and inner arches heavly corroded

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Tyre tread depth below requirements of 1.6mm 215 65 15 (5.2.3 (e)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pad(s) wearing thin PADS LOOK LOW BUT UNABLE TO SEE CLEARLY (1.1.13 (a) (ii))

rear arches and inner arches heavly corroded

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

osr bumper insecure, nsr inner wing and arch corroded

underside of vehicle corroded

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected rear inner wings (5.3.6 (a) (ii)) DANGEROUS

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Brake disc contaminated (1.1.14 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

underside of vehicle corroded in parts, rear wheel arches heavily corroded

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Rear Outer wheel arch corroded

Nearside Rear axle shaft seal shows signs of leaking on rear brake back plate

Oil leak, but not excessive (8.4.1 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Rear Outer wheel arch corroded

Nearside Rear axle shaft seal shows signs of leaking on rear brake back plate

Oil leak, but not excessive (8.4.1 (a) (i))

Front Tyre worn close to the legal limit both (4.1.E.1)

Nearside Rear Oil leak has slight leak from hub on axle ()

Oil leak ()

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak ()

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear wheel arches corroded

Offside Rear Anti-roll bar linkage cracked (2.4.G.1)

Oil leak ()

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear wheel arches corroded

Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

oil leak

Battery insecure (1.9.1)

Rear fog lamp not working (1.3.2b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear fog lamp not working (1.3.2b)

Oil leak

Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too low (1.8)

Front registration plate missing (6.3.1a)

Nearside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Nearside Headlamp incorrect colour (1.7.5b)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Rear fog lamp missing (1.3.2a)

Rear fog lamp switch missing (1.3.1a)

Rear fog lamp tell tale missing (1.3.1b)

Rear registration plate missing (6.3.1a)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)