1995 Peugeot Boxer

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Driver's door cannot be opened from inside the vehicle (6.2.3 (a))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Registration plate inscription illegible (0.1 (b))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced floor to sill (6.1.1 (c) (i))

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mounting. Side panel and rear crossmember (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mounting. Rear crossmember (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front very slight perishing to both front brake hoses

Rear very slight play in both rear wheel bearings

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill holed (6.1.B.2)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings centre sill holed (6.1.B.2)

Offside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings wheel arch holed with 30cms of engine mount and top shocker mount (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Brake hose bulging under pressure (3.6.B.3)

Towbar component insecure (6.6.1)

battery loose

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Brake pad(s) insecure (3.5.1g)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)