2013 Mercedes-benz C

Rear Subframe mounting prescribed area is corroded but not considered excessive Both rear bottom arm mounting points on subframe (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush excessively worn Marked yellow (5.3.4 (a) (i))

Parking brake lever ratchet not holding correctly (1.1.6 (a))

Registration plate does not conform to the specified requirements Front/rear (0.1 (d))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Subframe mounting prescribed area is corroded but not considered excessive Both bottom arm mounting points (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement Both front arm front bushes (5.3.4 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Suspension arm ball joint excessively worn rear bush (5.3.4 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)