1995 Rover 420

n/s/r tyre going flat

rear pivoit bushs spliting ,both headlight glass chipped ,drivers seat base loose ,n/s/r tyre going out of shape

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Exhaust system not adequately supported (7.1.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

handbrake high

n/s/r tyre going flat

rear pivoit bushs spliting ,both headlight glass chipped ,drivers seat base loose ,n/s/r tyre going out of shape

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Inner Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

nearside headlamp glass chipped.

nearside rear tyre worn to limit on inner edge.

Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Rear position lamp(s) excessively damaged so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

chips in front headlight glass

o/s/r tyre on limit n/s/r tyre going out of shape front brake pads low

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

o/s/r tyre worn low on inner edge..rear axle bushs perashing..slight bluing of o/s/r brake disc....

radiator in poor condition....engine getting very hot....oil leaks..front/rear exhaust corroded..o/s/f roll bar link bushs perashing..front brake pads 3/4 worn..

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Bonded suspension unit deteriorated and cannot function as intended (2.4.F.3)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside rear brake binding (3.7.B.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Bonded suspension unit deteriorated and cannot function as intended (2.4.F.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

pas pipe/by rad,becoming trapped..front exhaust corroding..cut in n/s/r inner side wall..nail in o/s/r tyre..front tyres low on tread........

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Driver's seat insecure (6.2.A.1)

Offside Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

advise rear brake check rear performance just past

major oil leak from engine

poly v belt perished

slight play in steering suspect uj but not visabal