1995 Mazda MX-5

Exhaust particulate filter missing where one was fitted as standard (8.2.1.1 (a))

Horn not working (7.7 (a))

Offside Front Body component corroded and likely to cause injury (6.2.1 (a) (i))

Offside Front Body panel corroded and likely to cause injury (6.2.1 (a) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Fuel tank exhaust shield missing where fitted as original equipment creating a risk of fire (6.1.3 (e)) DANGEROUS

Rear Anti-roll bar linkage pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Rear Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Power steering pipe/hose slightly damaged (2.1.5 (g) (i))

Battery insecure (1.9.1)

Body has a sharp edge caused by corrosion osf wing/both rear arches (6.1.C.1)

Exhaust has a major leak of exhaust gases cat flange joint rear (7.1.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Seat belt anchorage prescribed area is excessively corroded centre floor/inner sill (5.2.6)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Tyre tread depth below requirements of 1.6mm both sides inner edges (4.1.E.1)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Vehicle structure has excessive corrosion which adversely affects braking or steering both sides main chassis sections (6.1.A.1)

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Nearside Front Tyre worn close to the legal limit worn/perished outer edge (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced reflector dull (1.7.5a)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Rear Brake hose has slight corrosion to ferrules both sides (3.6.B.4e)

Rear Suspension arm corroded but not seriously weakened all 4 upper+lower (2.4.G.1)

Rear brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Vehicle structure has slight corrosion underside various places (6.1.A.1)

both sides front suspension arms corroded

Front brake disc worn, pitted or scored, but not seriously weakened Both (3.5.1i)

Nearside Rear Tyre worn close to the legal limit Inner Edge (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Tyre worn close to the legal limit Inner Edge (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened Both (3.5.1i)

Vehicle structure has slight corrosion General Underbody (6.1.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Power steering component(s) has slight seepage from a component (2.3.3b)

Vehicle structure has slight corrosion (6.1.A.1)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Power steering component(s) has slight seepage from a component (2.3.3b)

Vehicle structure has slight corrosion (6.1.A.1)

Offside (Reflector Dull) headlamp deteriorated but light output not reduced

Registration plate lamp not working (1.1.C.1d)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

both front and rear steel subframes badly corroded as is most other steel components.

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear brake disc excessively scored (3.5.1h)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake binding (3.7.B.1)

both front and rear steel subframes badly corroded as is most other steel components