1995 Honda Civic

Bonnet primary retaining device ineffective (3.1 (c))

Brake pedal has insufficient reserve travel Pedal goes to floor when testing rear brakes (1.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake fluid close to minimum mark On minimum level, warning light on dash (1.1.10 (d) (ii))

Central Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Engine throttle sticks open

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Upper Suspension locking device missing Ball joint nut (5.3.6 (b))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Trailing arm mounting (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Suspension arm pin or bush worn but not resulting in excessive movement all (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Body has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Body has slight corrosion (6.1.B.2)

Front Brake hose slightly deteriorated both (3.6.B.4d)

Body has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Body has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Front coil spring corroded (2.4.C.1b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

outer sill covers fitted

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Front coil spring corroded (2.4.C.1b)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

front brake juddering slightly (3.7.A.2b)

outer sill covers fitted