1995 Honda Civic

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Outer Rear Lower Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3) DANGEROUS

Offside Windscreen washer provides insufficient washer liquid (8.2.3) DANGEROUS

Brake pedal anti slip provision has a part worn smooth and has a small split on corner but remained secure at time of test

Car underbonnet battery is insecure which will soon become a reason for rejection (FAIL) so advise battery re-secured soon for safety purposes

Centre Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Clutch pedal anti slip has a large part worn smooth & is incomplete so unsafe. This will soon become a reason for rejection (FAIL) so advise replacement of rubber pad/anti slip provision required

Front registration plate delaminated but not likely to be misread (6.3.1d)

Heat shield on exhaust catalyst is part insecure & noisy when engine revs held to carry out emissions test

Offside front wing has a large damaged area but is `bolt-on` type so not a structuaral part of vehicle

Vehicle has sill covers obstructing some bodywork

Vehicle wet for inspection

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

covers on sills

Offside Front Tyre worn close to the legal limit (4.1.E.1)

covers on sills

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

outer sills plastic covered

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

outer sills plastic covered

Nearside Rear Lower Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Lower Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

outer sills plastic covered

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

outer sills plastic covered

0uter sills plastic covered

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

0uter sills plastic covered

outer sills plastic covered