2000 Mitsubishi Ralliart Fto

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded floor within lower arm mount (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Brake pipe slightly corroded front to rear pipe (3.6.B.2c)

Offside Brake pipe slightly corroded front to rear pipe (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

outer sills covered with plastic body kit

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wheel arch (6.1.B.2)

Rear fog lamp not working (1.3.2b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

outer sills covered with plastic body kit

N/S & O/S Inner sills slight corrosion

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Various places of under body corrosion not excessive at time of test.

Centre Stop lamp not working (1.2.1b)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Rear registration plate character(s) laid out in an incorrect format (6.3.4f)

Exhaust has a minor leak of exhaust gases (7.1.2)

Various places of under body corrosion not excessive at time of test

Nearside rear tyre slight splits in inner side wall

Offside rear tyre slight splits in inner side wall

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside rear tyre tread wear uneven

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside rear tyre tread wear uneven

Oil leak

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)