2006 Ford Ka

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive Wing (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive Wing (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Coil spring fractured or broken top of spring (5.3.1 (b) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive all under body floor and sills (5.3.6 (a) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive all under body floor and sills (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

exhaust corroded

front and rear coil springs corroded

under body and chasssis,component,corroded

Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected both inner rear arch (5.3.6 (a) (ii)) DANGEROUS

exhaust corroded

front and rear coil springs corroded

under body and chasssis,component,corroded

Coolant leak ()

Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear both sides (2.4.G.2)

Front floor pan areas corroded

Nearside Rear rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

both sides front chassis legs and subframe brakets corroded

Front chassis has slight corrosion

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

offside front tyre starting to wear on inner edge