1995 Porsche 911

Nearside Rear Tyre worn close to legal limit/worn on edge On legal limit (5.2.3 (e))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre worn close to legal limit/worn on edge On legal limit (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

under tray

Offside Front Suspension rod pin or bush excessively worn (5.3.4 (a) (i))

Brake pedal wearing smooth advise pedal rubber is smooth one side (1.1.2 (c))

Nearside Headlamp aim too low (4.1.2 (a))

oil leak from engine

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Lower Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Offside Registration plate lamp not working (1.1.C.1d)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

offside front brake disc inner surface pitted & grooved

offside front shock absorber top mounting rubber starting to split

Nearside Front Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)