1995 Ford Maverick

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Shock absorbers light misting of oil or has limited damping effect both front (5.3.2 (b))

all four wheel arches covered in tape no sharp edges at time of test

corrosion at both front body mountings and body mounting behind o/s/f wheel

Offside Front Headlamp aim not tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Shock absorbers light misting of oil or has limited damping effect both front (5.3.2 (b))

all four wheel arches covered in tape no sharp edges at time of test

corrosion at both front body mountings and body mounting behind o/s/f wheel

Body mounting fixing insecure, but overall security not significantly reduced corrosion to n/s front of front body mounting (6.2.2 (c) (i))

Brake pipe corroded, covered in grease or other material front,front to rear and rear (1.1.11 (c))

no rear seat belts or seats fitted at time of test

Parking brake efficiency below requirements (1.4.2 (a) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced both rear seat belt mountings (7.1.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Tyre(s) of different sizes are fitted on the same axle. front and rear (5.2.3 (b))

Body mounting fixing insecure, but overall security not significantly reduced corrosion to n/s front of front body mounting (6.2.2 (c) (i))

Brake pipe corroded, covered in grease or other material front,front to rear and rear (1.1.11 (c))

Offside Rear Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Shock absorbers light misting of oil or has limited damping effect all 4 front & rear (5.3.2 (b))

all 4 wheel arches covered in tape

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Shock absorbers light misting of oil or has limited damping effect all 4 front & rear (5.3.2 (b))

all 4 wheel arches covered in tape

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced Rear of inner sill (7.1.1 (a) (i))

Service brake is causing the steering wheel to severely pull one way (1.2.1 (b) (i))

Nearside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive Rear of outer sill (7.1.1 (a) (i))

Exhaust has a major leak of exhaust gases centre and rear section (7.1.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering cross member to chassis (6.1.A.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Brake hose leaking (3.6.A.1)

Service brake is causing the vehicle to swerve to the nearside (3.7.C.2)

Front Brake pad(s) wearing thin (3.5.1g)

rear exhaust is corroded

Offside Side repeater not working (1.4.A.2c)

exhaust has slight corrosion

exhaust has slight corrosion

Offside Rear Vehicle structure has a fracture which adversely affects braking or steering (6.1.A.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

L/H side step slightly insecure

rear diff locked

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Stop lamp not working (1.2.1b)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

near side rear tyre has age cracks on sidewall † (not cracked to cords)