2000 Fiat Hymer

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced step floor area (around rubber bung) (6.1.1 (c) (i))

Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Brake pipe corroded, covered in grease or other material Across back axle (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Outer Driver's door catch deteriorated so the door cannot be readily opened or closed (6.2.3 (c) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Outer Driver's door catch deteriorated so the door cannot be readily opened or closed (6.2.3 (c) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Headlamp insecure (4.1.1 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Emissions not tested Major leak of exhaust gases (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust system insecure (6.1.2 (a))

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

gas tank underneath has surface corrosion

2 exhaust rubber rings required

corrosion on front crossmember, advise treatment

exhaust tail pipe snapped off due to corrosion, but blowing hot fumes close to external gas tank

front brake pads look low but difficult to see

Exhaust system not adequately supported (7.1.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

rear tyres have cracks in outer walls asap/

all tyres have strss cracks in walls