1995 Rover Mini

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced body sill step (7.1.1 (a) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced body sill area (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced 1/4 panel area (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor / jacking point area (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength valance (5.3.6 (a) (i))

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers has negligible damping effect (5.3.2 (d))

Nearside Front Tyre worn close to legal limit/worn on edge worn inner edge 1.8 mm (5.2.3 (e))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive body sill area (7.1.1 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn inner edge (5.2.3 (e))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Side repeater not working (4.4.1 (a) (ii))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Floor corroded

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner panel corroded by windscreen

Offside Front Sill corroded

Nearside Front floor corroded/ holed by corrosion out side prescribed area

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front floor corroded/ holed by corrosion out side prescribed area

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner wheel arch (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced body sill area (7.1.1 (a) (i))

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Headlamp aim not tested (1.8.A.1c)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front exhaust mounting bracket broken

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Steering rack gaiter split (2.2.D.2d)

Stop lamp remains on when the brakes are released (1.2.1e)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

off side rear tyre side wall cracking badly

Nearside Headlamp not working on dipped beam (1.7.5a)

o/s/r tyre side wall cracking badly

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

o/s/r tyre side wall cracking badly

near side outer sill badly corroded with no! holes outside all prescribed areas

off side outter sill badly corroded & holed but out side all prescribed areas

off side rear brake slight drag