1998 Mitsubishi Fto

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Rear Inner Seat belt anchorage prescribed area is excessively corroded arch (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Nearside Steering rack gaiter insecure (2.2.D.2d)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Rear Inner Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Steering rack gaiter insecure (2.2.D.2d)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) DANGEROUS

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) DANGEROUS

Brake pipe slightly corroded all (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Fuel Pipe/s corroded ()

Oil leak ()

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

under side rusty and poor

front screen chipped,car heavily undersealed underside,various rust under car,bodykit fitted,rear brake discs rusty.

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Upper Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Child seat fitted not allowing full inspection of adult belt

Front Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Valve stem slightly damaged (4.1.D.1e)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Valve stem slightly damaged (4.1.D.1e)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Oil leak

Play in steering rack inner joint(s)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2) DANGEROUS

rear brake recording little or no effort (3.7.B.5a) DANGEROUS

front screen chipped,car heavily undersealed underside,various rust under car,bodykit fitted,rear brake discs rusty.

Brakes imbalanced across an axle (3.7.B.5b)

Horn not working (1.6.2a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Horn not working (1.6.2a)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Front front brake juddering slightly (3.7.A.2b)

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension arm slightly distorted (2.4.G.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n/s/r tyre out of shape †osr body repairs incomplete behind bumper