1995 Mercedes-benz C

Front Oil leak but not excessive

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Suspension component ball joint has slight play Both side (5.3.4 (a) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced both side covered with under seal (6.1.1 (c) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Fuel Pipe/s corroded ()

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both side covered with under seal (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced covered with under seal front to rear (6.1.1 (c) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area fractured significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area fractured significantly reducing structural strength (5.3.6 (a) (i))

Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Oil leak but not excessive

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Suspension component ball joint has slight play Both side (5.3.4 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Fuel Pipe/s corroded ()

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Boot Floor (6.1.1 (c) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Boot Floor (6.1.1 (c) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak ()

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

floor/sill corroded

fuel pipe corroded

oil leak

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

n/s/f trye bulge

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

n/s/f trye bulge

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

disc worn rear

Front bumper insecure

Oil leak

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)