2000 Yamaha Yzf R1

Drive chain slightly tight (6.1.7 (k) (i))

Front Brake indicates excessive fluctuation of brake effort (1.2.1 (e))

Drive chain slightly tight (6.1.7 (k) (i))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement SLIGHT PLAY IN SUSPESION LINKAGE (5.3.4 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps REPLACED DURING TEST (4.7.1 (b) (ii))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement SLIGHT PLAY IN SUSPESION LINKAGE (5.3.4 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake indicates excessive fluctuation of brake effort FRONT BRAKE DISC/S WARPED (1.2.1 (e))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Tyre worn close to the legal limit 1MM TREAD LEFT (1MM THE MIN LIMIT) (5.2.3 (e))

Rear Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Tyre worn close to the legal limit 1MM TREAD LEFT (1MM THE MIN LIMIT) (5.2.3 (e))

Exhaust noisy (8.1.1 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Lower Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement mono-shock linkage (5.3.4 (a) (i))

Front Roller brake test indicates slight fluctuation of brake effort and rear (3.3.A1d)

Lower Rear suspension bearing has slight free play (2.4.A2a(i))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Front Tyre worn close to the legal limit (4.1.3(ii))

offside front handlebar/clip on slioghtly bent

Exhaust mounting does not fully support the exhaust system missing mounting rubber (7.1.1.c)

Front Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Nearside Rear Direction indicators not working (1.5.1c)

Drive chain slightly loose (6.2.1d)

Front Tyre worn close to the legal limit (4.1.3(ii))

Offside Front handlebar/cilp on slightly bent

Exhaust mounting does not fully support the exhaust system missing mounting rubber (7.1.1.c)

Front Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Nearside Rear Direction indicators not working (1.5.1c)

Drive chain slightly loose (6.2.1d)

Offside Front handlebar/cilp on slightly bent

Offside Rear Direction indicators not working (1.5.1c)

Rear reflector on motorcycle missing (1.4.1)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake disc(s) has slight run out (3.2.A1m)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Brake disc(s) has slight run out (3.2.A1m)

Front Brake fluid reservoir fluid level low (3.2.B1d)

Nearside Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Offside Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake disc(s) slightly scored (3.2.A1l)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear wheel bearings have slight free play (2.4.A.2c)