2004 Mazda Eunos

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Sill showing signs of corrosion (6.1.1 (c) (i))

Oil leak

Rear Lower Shock absorbers has a slightly worn bush BOTH SIDES (5.3.2 (c))

Offside Rear Lens defective

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases Mid section (6.1.2 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Offside Rear Lens defective

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Fog Lamp, Fog Lamp Switch and Fog Lamp Tell Tale temperamental in operation.

Rear Exhaust has a minor leak of exhaust gases at previous repair (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

all anti roll bar bushes deteraited

corroded both sides of rear inner cill

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Exhaust has a minor leak of exhaust gases At previously repaired section (6.1.2 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced slight corrosion at wheel arches and underside chassis (6.1.1 (c) (i))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Central Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Headlamp aim too high both (1.8)

Offside Front front brake binding (3.7.B.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Upper Ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Nearside front brake binding (3.7.B.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

front brake application uneven (3.7.B.2)

Exhaust has a minor leak of exhaust gases exhaust system corroded (7.1.2)

Nearside Front Upper Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

front discs heavily corroded pads low

Nearside Front Upper Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Oil leak

Emissions not tested (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside front brake binding (3.7.B.1)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Upper Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front brake disc slightly pitted (3.5.1h)

Rear brake disc slightly pitted (3.5.1h)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Front brake disc slightly pitted (3.5.1h)

Rear brake disc slightly pitted (3.5.1h)