1994 Suzuki SJ413

Brake pipe excessively corroded o/s chassis from load valve (yellow chalk) (1.1.11 (c))

Brake pipe excessively corroded o/s chassis too load valve (1.1.11 (c))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases centre box (6.1.2 (a))

Front Registration plate missing (0.1 (a))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting complete inner wing (6.2.2 (d) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis mounting (yellow chalk) (5.3.6 (a) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting complete inner wing (6.2.2 (d) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake hydraulic reservoir fluid level below minimum level (1.1.10 (d) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Seat belt flexible stalk damaged both front (7.1.2 (b) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Front Vehicle structure has slight damage crossmember (6.1.A.1)

Offside Front Axle swivel joint has slight play upper and lower (2.5.A.3b)

Rear Brake pipe slightly corroded o/s and n/s (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Leaf spring to axle securing bolt insecure o/s and n/s (2.4.B.7b)

Service brake: efficiency below requirements (3.7.B.7)

Speedometer clearly inoperative (6.7.2)

Steering lock fails to engage (2.1.4b)

Front Vehicle structure has slight damage crossmember (6.1.A.1)

Offside Front Axle swivel joint has slight play upper and lower (2.5.A.3b)

Rear Brake pipe slightly corroded o/s and n/s (3.6.B.2c)

Nearside Front Front position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Rear wheel bearing has slight play (2.6.2)

Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Registration plate lamp not working (1.1.5c)