1995 Toyota MR2

Offside Rear Anti-roll bar linkage pin or bush excessively worn bush (5.3.4 (a) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill (6.1.1 (c) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner and outer sill (6.1.1 (c) (i))

Offside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Tyre worn close to the legal limit both rear (4.1.E.1)

general underbody corrosion

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Coil spring mounting corroded but not seriously weakened (2.4.C.3c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Shock absorber has slight corrosion to the casing (2.7.2a)

both front brake disc inner faces corroded and in poor condition

both inner sills at rear rotten

both rear inner wheel arches rotten

coil spring corroded (2.4.C.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside front brake binding (3.7.B.1)

Offside Brake cable has a seized clevis joint pivot (3.5.1c)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front An item not tested (Manual)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

All tyres bald on inner edges

Nearside rear strut brace corroded and seriously weakened

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

n/s/f tyre small cuts to outer sidewall

o/s/f tyre small cut to outer sidewall

rear chassis stabiliser bars slightly corroded