1994 Rover Mini

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Drag link end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing and sill (5.3.6 (a) (i))

Offside Front Drag link end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Hydraulic brake calliper leaking (1.1.16 (b) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch and sill (5.3.6 (a) (i))

Offside Rear Rear fog lamp does not emit a steady red light (4.5.4 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Windscreen washer not working (3.5 (a))

Windscreen wiper not working (3.4 (a))

Nearside Front Shock absorbers missing (5.3.2 (a) (ii)) DANGEROUS

Nearside Front Upper Suspension component missing shock absorber mounting bracket missing (5.3.3 (a) (ii)) DANGEROUS

heavily under sealed

Emissions unable to be completed due to fuel leak. (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust system insecure (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced sill holed. (7.1.1 (a) (i))

Nearside Headlamp aim too high and too far to the left. (4.1.2 (a))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Headlamp aim too high and too far to the left. (4.1.2 (a))

Offside Rear Brake cable insecure (1.1.15 (c))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor holed. (5.3.6 (a) (i))

Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Passenger's seat insecure (6.2.6 (a) (ii)) DANGEROUS

Fuel hose so insecure there is a risk of fire to fuel filter (6.1.3 (a) (ii)) DANGEROUS

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear fog lamp starting to emit white light

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear fog lamp starting to emit white light

Wheel/tyre protruding beyond wheel arch

front bump stops missing

front tie bars bent slightly

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Parking brake mechanism/associated mounting prescribed area is excessively corroded centre floor (1.1.21 (e) (i))

Offside Front Brake hose excessively twisted (1.1.12 (b) (ii))

Wheel/tyre protruding beyond wheel arch

front bump stops missing

front tie bars bent slightly

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelarch around nsr mounting (5.3.6 (a) (i))

Nearside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Shock absorber - top mounting area (5.3.6 (a) (i))

Rear Sub-frame corroded and seriously weakened on offside (5.3.3 (b) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Emissions not tested (8.2.1.2 (d))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 29% (1.2.1 (b) (i))

Rear tail pipe corroded

corrosion on both outer sills

corrosion on front and rear floor sections

corrosion on front and rear subframes

corrosion on front inner wings

corrosion on front floor sections and rear floor sections

corrosion on rear subframe

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

both rear tyres have tread cracking

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

both rear tyres have tread cracking

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp not working on main beam (1.7.5a)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)