1994 Fiat Uno

Brake load sensing valve seized (3.6.E.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Stop lamp not working (1.2.1b)

Nearside Suspension component mounting prescribed area is excessively corroded at inner sill area (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded at sill area (2.4.A.3)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front brake fluctuating, but not excessively (3.7.B.3)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Headlamp not working on main beam (1.7.5a)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Coolant leak

Oil leak

Shock absorber has a slightly reduced damping effect (2.7.5)

front brake juddering slightly (3.7.A.2b)

Centre Exhaust system not adequately supported (7.1.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside front brake binding (3.7.B.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Shock absorber has an excessively worn bush (2.7.4)

Coolant leak

Oil leak

Shock absorber has a slightly reduced damping effect (2.7.5)

front brake juddering slightly (3.7.A.2b)

Oil leak

Slight imbalance at rear brakes 21%

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Headlamp aim too high (1.8)

Oil leak

Slight imbalance at rear brakes 21%

Brake load sensing valve linkage defective and function impaired (3.6.E.3)

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Headlamp aim too high (1.8)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside front brake binding (3.7.B.1)

Offside Inner Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Outer Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brake application uneven (3.7.B.2)

Brake load sensing valve linkage defective and function impaired (3.6.E.3)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.5c)

rear brake application uneven (3.7.B.2)

Brake pipe excessively corroded (3.6.B.2c)

engine oil leak

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim too high (1.8)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)