1995 Toyota MR2

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

All four brake disc backing plates slight corrosion

All four brake disc backing plates slight corrosion

Registration plate lamp inoperative in the case of a single lamp or all lamps Both rear (4.7.1 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

slight corrosion in nearside and offside outer sills

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside front brake binding (3.7.B.1)

Nearside rear brake binding (3.7.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Tyre worn close to the legal limit (4.1.E.1)

slight play in steering rack

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside front brake binding (3.7.B.1)

Nearside Headlamp aim too low (1.8)

Nearside Macpherson strut upper support bearing is stiff in operation (2.5.B.1b)

Offside Front An item not tested (Manual)

Offside Front Road wheel bead rim badly distorted (4.2.A.1a)

Offside Headlamp aim too far to the right (1.8)

Offside front brake binding (3.7.B.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Fuel pipe/s corroded

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake juddering slightly (3.7.A.2b)

wheel centers covered

Exhaust has part of the system slightly deteriorated (7.1.1a)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front An item not tested (Manual)

Nearside front brake binding (3.7.B.1)

Offside Front An item not tested (Manual)

Offside Registration plate lamp not working (1.1.5c)

Offside front brake binding (3.7.B.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)

o/s/r wheel bearing slightly noisy