1995 Saab 9000 Cs

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tie bar (5.3.6 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tie bar (5.3.6 (a) (i))

Offside Windscreen washer not working (3.5 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive tie bar (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive tie bar (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength suspension top (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive tie bar (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive tie bar (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor to sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive suspension top (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area damaged but not considered excessive floor to sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area damaged but not considered excessive suspension top (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded shockabsorber (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded tie bar (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded trailing arm (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded shockabsorber (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded tie bar (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded trailing arm (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

clutch pedal anti slip rubber slightly worn

corrosion in exhaust system

exhaust system has small hole in rear section

o/s/f outer cv boot slightly deteriorated

slight corrosion in centre front brake pipe

Nearside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement D bush (2.4.G.2)

Nearside rear brake binding (3.7.B.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement D bush (2.4.G.2)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

clutch pedal anti slip rubber slightly worn

corrosion in exhaust system

exhaust system has small hole in rear section

handbrake lever has little reserve travel

o/s/f outer cv boot slightly deteriorated

o/s/r foot brake and hand brake effort lower than n/s/r

slight corrosion in centre front brake pipe

Offside Rear Direction indicator not working (1.4.A.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front exhaust clamp cracked

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front number plate damaged

offside handbrake percentage low

Offside Front Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Direction indicators not working (1.4.A.2c)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning tell tale not working correctly (1.4.B.1e)

Indicator tell tale inoperative (1.4.A.2a)

Offside Front Brake hose excessively chafed (3.6.B.4d)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Lower Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

coolant leaking

oil leak

Nearside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)