2006 Honda XR125L

Front Stop lamp not working (4.3.1 (a) (ii))

Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii))

rear shockabsorber as reduced damping

chain slightly loose

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

full beam switch wired incorrectly

Drive chain slightly loose needs adjustment or repair

Some loose wiring under front but not dangerous

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

cable ties secuing instrument panel

cable ties securing front indicators

front brake fluid on minimum level

incorect footrest fited on offside

rear disc scored

Drive chain worn to excess (6.2.1e)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Roller brake test Higher brake efficiency normally obtainable. (3.3.A2a)

cable ties secuing instrument panel

cable ties securing front indicators

front brake fluid on minimum level

incorect footrest fited on offside

rear disc scored

Rear Drive chain worn but not considered excessive (6.2.1e)

Wheel alignment slightly misaligned. (2.5.1)

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Brake disc(s) is excessively distorted (3.2.A1m)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Drive chain worn but not considered excessive (6.2.1e)

Wheel alignment slightly misaligned. (2.5.1)

wheels slightly out of line