2006 Peugeot 107

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear Bush (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear Bush (5.3.4 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Nail in tyre ()

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Spare tyre defective FLAT ()

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Outer Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement suspension arm rear mounting bush (5.3.4 (a) (i))

Nearside Rear parking brake slower to react and over all result poor comapared offside

Offside Front Outer Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement suspension arm rear mounting bush (5.3.4 (a) (i))

Offside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. slower to react (1.2.1 (b) (i))

Offside Rear Rear reflector insecure (4.8.1 (b) (i))

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Exhaust has a major leak of exhaust gases joint to rear back box (7.1.2)

Offside Rear Registration plate lamp not working fitting insecure (1.1.C.1d)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Spare tyre defective

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Upper Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Tyre worn close to the legal limit (4.1.E.1)

Wiper blade deteriorated.

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Upper Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Tyre worn close to the legal limit (4.1.E.1)

Wiper blade deteriorated.

Centre Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

n/s/f tyre worn close to legal limit on 2.0mm and cuts in outter sidewall

nails in o/s/r tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)