2008 Toyota Aygo

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both side's (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner/outer sill (6.1.1 (c) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner/outer sill (6.1.1 (c) (i))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Rear Brake pipe excessively corroded from flexi to cylinder (1.1.11 (c))

Offside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mount (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material Both rear sections of front to rears (1.1.11 (c))

Vehicles internal headlight adjuster altered to recheck lights

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material Both rear sections of front to rears (1.1.11 (c))

Vehicles internal headlight adjuster altered to recheck lights

Front Wiper streaky

Vehicles internal headlight adjuster altered to recheck lights

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Mechanical brake component has restricted free movement Brake excessive bind (3.5.1k)

Windscreen washer provides insufficient washer liquid (8.2.3)

registration plate insecure (6.3.1b)

Vehicles internal headlight adjuster altered to recheck lights

Offside Stop lamp not working (1.2.1b)

Exhaust mount broke but exhaust still supported

Offside Rear Brake slightly binding

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Front registration plate incorrect (6.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear registration plate incorrect (6.3.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Items removed from driver's view prior to test

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)