2008 Toyota Aygo

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced under body (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Vehicle structure is corroded but structural rigidity is not significantly reduced under body (6.1.1 (c) (i))

Brakes imbalanced across an axle n/s rear (1.2.1 (b) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Headlamp aim too low o/s (4.1.2 (a))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed and corroded (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed and corroded (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material n/s/r (1.1.11 (c))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear wheels slightly stiff in rotation when jacked up

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear wheels slightly stiff in rotation when jacked up

Stop lamp(s) all not working (4.3.1 (a) (iii))

Rear slightly stiff in rotation

rear exhaust bracket secured with wire

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both sides (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both sides (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)