2002 Lexus IS200

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen washer not working (3.5 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Service brake excessively fluctuating (1.2.1 (e))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front front brake binding (3.7.B.1)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Power steering component(s) has slight seepage from a component (2.3.3b)

Steering system slightly tight (2.2.D.1)

Battery insecure (1.9.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside Rear Brake back plate(s) securing device excessively deteriorated (3.5.1j)

Offside Front Lower Ball joint has excessive play (2.2.B.1f)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Steering column flexible coupling is excessively deteriorated (2.1.5)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Power steering component(s) has slight seepage from a component (2.3.3b)

Steering system slightly tight (2.2.D.1)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

both front tyres worn on inner edge @ 0mmm advise replacement and alignment

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

both front tyres worn on inner edge @ 0mmm advise replacement and alignment

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)