2007 Honda Accord

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Service brake binding but not excessively nearside front and offside rear (1.2.1 (f))

nearside and offside underbody sill seat belt anchorage prescribed area weld repair covered in underseal

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

slight corrosion to floor

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Upper Ball joint has excessive play (2.2.B.1f)

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working Both (1.1.C.1d)