2008 Toyota Aygo

Lower Vehicle structure is corroded but structural rigidity is not significantly reduced SILLS - BOTH (6.1.1 (c) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn BOTH axle bushes (5.1.2 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Front Brake disc significantly and obviously worn BOTH (1.1.14 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened BOTH - inner surfaces (1.1.14 (a) (ii))

Offside Front Coil spring corroded lower coil (5.3.1 (b) (i))

Offside Rear Coil spring corroded lower coil (5.3.1 (b) (i))

Rear Tyre slightly damaged/cracking or perishing BOTH (5.2.3 (d) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Tyre slightly damaged/cracking or perishing BOTH (5.2.3 (d) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge @ 2.5mm (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge @ 3mm (5.2.3 (e))

BOTH front tyres wearing inner/outer edges

Rear Coil spring corroded BOTH (5.3.1 (b) (i))

brake cable under dashboard from towing A frame to brake pedal is broken .

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

all tyres cracked + perished in tread

exhaust system slightly corroded

front brake discs slightly corroded

Nearside Front Sub-frame damaged but not seriously weakened (2.4.G.1)

Offside Headlamp not working on dipped beam (1.7.5a)