2006 Toyota Aygo

Brake pipe corroded, covered in grease or other material front and rear both sides (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension component corroded but not seriously weakened both sides (5.3.3 (b) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened both sides (5.3.3 (b) (i))

underbody has general corrosion

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front surface corrosion front discs

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Suspension component corroded but not seriously weakened all (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction EMWL does not illuminate. DTC present which would normally illuminate lamp. (8.2.1.2 (h))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Rear axle mount and surrounding support panelling. Perforated and flexing under thumb pressure. (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside parking brake low effort and not locking.

Sub-frame corroded but not seriously weakened Rear axle assembly. (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Underside of vehicle, front and rear, central, and both sides: Floors, sill returns, and other structural areas all have visible corrosion. No perforation noted. (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement o/s & n/s (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge o/s & n/s (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pipe excessively corroded o/s & n/s rear mains (1.1.11 (c))

Emissions not tested from cat back over (8.2.1.2 (d))

Headlamp aim projected beam image is obviously incorrect o/s & n/s (4.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement o/s & n/s (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge o/s & n/s (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Central Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Central Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Nearside Brake pipe corroded, covered in grease or other material main feed (1.1.11 (c))

Offside Brake pipe corroded, covered in grease or other material main feed (1.1.11 (c))

Brake performance not tested (1.2.1 (g))

Nearside Rear Parking (secondary brake) on a single line braking system grabbing severely (1.3.1 (c))

Offside Rear Parking (secondary brake) on a single line braking system grabbing severely (1.3.1 (c))

Nearside Brake pipe corroded, covered in grease or other material main feed (1.1.11 (c))

Offside Brake pipe corroded, covered in grease or other material main feed (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front brake discs corroded and pitted

Rear outer brake pipes starting to show corrosion

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)