2008 Ford Ka

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

all chassis rusty

front inner wings rusty

rust, corrosion & welded patches in various places....

slight weqar/play in front lower arm bushes & top mounts

Suspension component mounting prescribed area is corroded but not considered excessive all over & front inner arches!! (5.3.6 (a) (i))

front lower arm bushes splitting away

fuel filler neck loose

small dents on rims

Brake fluid contaminated (1.8 (a))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch/wing (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive all over & front inner arches!! (5.3.6 (a) (i))

front lower arm bushes splitting away

fuel filler neck loose

small dents on rims

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Child seat fitted not allowing full inspection of adult belt

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Child seat fitted not allowing full inspection of adult belt