2005 Audi A4

Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

SERVICE LAMP ON

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

SERVICE LAMP ON

Front Brake disc worn, but not excessively both sides lipped. (1.1.14 (a) (i))

Front Headlamp lens slightly defective both lenses slightly hazy. (4.1.1 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated outer ball joint. (5.3.4 (b) (i))

Rear Brake disc worn, but not excessively both sides lipped (1.1.14 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides. (5.3.6 (a) (i))

Towball/hitch not fitted at time of test ()

Central Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Side repeater light intensity significantly reduced (4.4.3 (a))

Front Brake disc worn, but not excessively both sides lipped. (1.1.14 (a) (i))

Front Headlamp lens slightly defective both lenses slightly hazy. (4.1.1 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated outer ball joint. (5.3.4 (b) (i))

Rear Brake disc worn, but not excessively both sides lipped (1.1.14 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides. (5.3.6 (a) (i))

Towball/hitch not fitted at time of test ()

Central Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Coolant leak ()

Front Brake disc worn, but not excessively BOTH SIDES SLIGHTLY LIPPED. (1.1.14 (a) (i))

Nearside Front Tyre slightly damaged OUTER WALL (5.2.3 (d) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Brake disc worn, but not excessively BOTH SIDES SLIGHTLY LIPPED. (1.1.14 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake disc worn, but not excessively both sides slightly lipped. (1.1.14 (a) (i))

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Nearside Rear Road wheel slightly distorted outer rim slightly damaged. (5.2.2 (c) (i))

Nearside Rear Tyre slightly damaged (5.2.3 (d) (ii))

Rear Brake disc worn, but not excessively both sides slightly lipped. (1.1.14 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides slightly corroded. (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides rear shock absorbers mounts prescribed areas slightly corroded. (5.3.6 (a) (i))

engine covers and undertrays fitted obscuring testable items from views of the test.

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Nearside Rear Outer Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides slightly lipped. (1.1.14 (a) (ii))

Nearside Front Tyre slightly damaged outer wall. (5.2.3 (d) (ii))

Nearside Rear Road wheel slightly distorted outer rim. (5.2.2 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive shock absorber mounting area / inner wing (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged outer wall. (5.2.3 (d) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive shock absorber mounting area / inner wing. (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides. (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged outer wall. (5.2.3 (d) (ii))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides. (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides rear coil spring mounting areas. (5.3.6 (a) (i))

Towball/hitch not fitted at time of test ()

engine covers and undertrays fitted obscuring testable items from view of the test.

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Side repeater incorrect colour (4.4.3 (a))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Central Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre slightly damaged outer wall. (5.2.3 (d) (ii))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides. (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides rear coil spring mounting areas. (5.3.6 (a) (i))

Towball/hitch not fitted at time of test ()

engine covers and undertrays fitted obscuring testable items from view of the test.

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Brake pad(s) wear indicator illuminated (1.1.13 (a) (i))

Nearside Front Upper Suspension arm pin or bush excessively worn front (5.3.4 (a) (i))

Nearside Rear Brake hose excessively damaged (1.1.12 (b) (ii))

Offside Front Upper Suspension arm pin or bush excessively worn front (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Rear Brake hose excessively damaged (1.1.12 (b) (ii))

Battery insecure (1.9.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

offside front tyre has slight damage to side wall

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

offside front tyre has slight damage to side wall

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp aim too high (1.8)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

O/S/F TYRE WEARING ON INNER AND OUTER EDGES

REAR ANTI ROLL BAR BUSHES SPLIT

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)