2008 Ford Ka

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Front Exhaust system insecure flexi pipe detached (6.1.2 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill area (6.2.2 (d) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill area (6.2.2 (d) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced leg to boot area (6.1.1 (c) (i))

Exhaust mounting defective front to center mount broke (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases section (6.1.2 (a))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced and both rear inner sills (6.1.1 (c) (i))

Nearside Rear Position lamp not working (4.2.1 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Front Tyre worn close to legal limit/worn on edge both 3mm sized 165 60 14 (5.2.3 (e))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced and both rear inner sills (6.1.1 (c) (i))

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement both sides (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Offside Front Road wheel fractured (4.2.B.1a) DANGEROUS

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Road wheel slightly damaged (4.2.A.1a)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Inner Tyre has a lump, caused by separation or partial failure of its structure inside side wall (4.1.D.1b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Road wheel slightly damaged (4.2.A.1a)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

n/s/r wheel rim buckled on inner side

o/s/f wheel rim buckled on inner side

Nearside Rear position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)