2001 Toyota MR2

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Nail in tyre

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake hose slightly deteriorated Both (1.1.12 (b) (ii))

Brake disc worn, pitted or scored, but not seriously weakened Front & Rear (1.1.14 (a) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Upper Coil spring corroded (5.3.1 (b) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Upper Coil spring corroded (5.3.1 (b) (i))

Rear Outer corroded both sides

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak

engine mag light on

Emissions not tested (7.0)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

rear parking brake recording little or no effort (3.7.B.6a)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

engine mag light on

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Wheel nut(s) missing (4.2.A.1e)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Suspension arm severely distorted (2.4.G.1) DANGEROUS

offside front lower arm slight damage

vehicle pulling left to right when driven on road

Nearside Rear Registration plate lamp not working (1.1.5c)

Nearside front brake juddering severely (3.7.A.2b)

Offside Front Anti-roll bar attachment bracket/mounting damaged and its strength is seriously reduced (2.4.G.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.C.1b)

front brake application uneven (3.7.B.2)

offside front lower arm slight damage

vehicle pulling left to right when driven on road

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

o/s front drop linkage bent

o/s front lower arm slight damage

rear brake pads low

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

offside front wishbone and anti-roll bar drop link both damaged.when jacked up anti-roll bar drop link catches shock absorber