2002 Fiat Punto

Emissions not tested Overheating (8.2.1.2 (d))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner and outer sill (6.1.1 (c) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Floor pan (7.1.1 (a) (i))

Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Both inner wheel archs (6.1.1 (c) (i))

General underbody corrosion

Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced Floor pan to inner sill (6.1.1 (c) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Floor pan to inner sill (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Outer Drive shaft joint constant velocity boot severely deteriorated Both (6.1.7 (g) (i))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both rear inner sills and general under body corrosion. Both rear floor pans (6.2.2 (d) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Body has slight corrosion General corrosion (6.1.B.2)

Condition of n/s/f tyre

Headlamp deteriorated but light output not reduced Both (1.7.5a)

Nearside Body has slight corrosion Floor pan to inner sills (6.1.B.2)

Offside Body has slight corrosion Floor pan to inner sills (6.1.B.2)

Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt Both (2.5.C.1a)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Both (2.4.G.2)

General underbody corrosion

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Oil leak

Brake hose has slight corrosion to ferrules (3.6.B.4e)

blow from exhaust system.

surface corrosion to sill to floors.

surface corrosion to suspension components(front subframe,rear axle).

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

blow from exhaust system.

surface corrosion to sill to floors.

surface corrosion to suspension components(front subframe,rear axle).

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

corrosion to front subframe & rear axle beam.

nearside rear tyre wear low.

surface corrosion to various metal brake pipes.

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

condition of n/s/r tyre

Offside Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Headlamp aim too low (1.8)

Offside Front Brake hose twisted (found during steering lock to lock check) (2.2.D.2b)

Offside Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Oil leak

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Oil leak

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front brake disc slightly scored (3.5.1h)

Oil leak

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has part of the system slightly deteriorated (7.1.1a)