2008 Ford Ka

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Inner Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Inner Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Inner Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both side (6.2.2 (d) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Offside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Exhaust system not adequately supported (7.1.1)

Rear Registration plate lamp not fitted (1.1.C.1b)

Nearside Front Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front discs worn

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)