2001 Volkswagen Caddy

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced underside of vehicle corroded including brake and suspension components (6.1.1 (c) (i))

Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced both floors corroded and holed (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced underside of vehicle corroded including brake and suspension components (6.1.1 (c) (i))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

air filter insecure

engine oil on minimum

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

air filter insecure

engine oil on minimum

Nearside Front Lower Suspension arm ball joint likely to become detached pinch bolt loose (5.3.4 (a) (ii))

Brake pipe corroded, covered in grease or other material all pipes into and out of brake biest load valve (rear) (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Oil leak, but not excessive engine oil (8.4.1 (a) (i))

both handbrake cables are hanging down

parking brake lever has travel but not excessive

Brake valve leaking rear load biest valve (1.1.7 (d) (i))

Nearside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Nearside Headlamp aim too low pattern also incorrect and beam pattern hitting floor not forward (4.1.2 (a))

Offside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment comes to stop (1.1.6 (c))

Service brake efficiency below requirements (1.2.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive engine oil (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material all pipes into and out of load biest valve (1.1.11 (c))

both handbrake cables hanging down

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear axle to wheel bearings modified

front and rear suspension has been modified and lowered

Front Windscreen washer not working (3.5 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front Suspension arm ball joint likely to become detached not fit correctly also pinch bolt nut loose (5.3.4 (a) (ii)) DANGEROUS

Offside Front Suspension arm insecure and impairing directional stability ball joint not fit correctly also main pinch bolt nut not tightened up (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear axle to wheel bearings modified

front and rear suspension has been modified and lowered

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Non obligatory mirror damaged

Nearside Front Suspension component mounting repair covered in underseal at anti roll bar mount to floor (5.3.6 (a) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength at anti roll bar to floor behind subframe (5.3.6 (a) (i))

Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Non obligatory mirror damaged

Nearside Front Suspension component mounting repair covered in underseal at anti roll bar mount to floor (5.3.6 (a) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Brake hose bulging under pressure (3.6.B.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Direction indicator has less than 50% of the light sources illuminating (1.4.A.2c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/f tyre worn on inner

slight roughness in n/s/r wheel bearing

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Handbrake has little reserve travel.

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake load sensing valve linkage seized (3.6.E.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Registration plate lamp not working (1.1.5c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)