2004 Fiat Punto

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Front Brake pipe corroded, covered in grease or other material UNDER BRAKE SERVO (1.1.11 (c))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Steering component mounting prescribed area is corroded but not considered excessive (2.1.2 (e) (i))

Rear Brake actuating linkage mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive REAR AXLE (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Outer Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Macpherson strut mounting likely to fail Bearing grinding. (5.3.3 (b) (ii)) DANGEROUS

Offside Front Lower Suspension rod ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust mounting defective Exhaust mounting perished and split. (6.1.2 (a))

Oil leak, but not excessive from engine (8.4.1 (a) (i))

Brake fluid contaminated (1.8 (a))

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Oil leak, but not excessive from engine (8.4.1 (a) (i))

Items removed from driver's view prior to test ()

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rusty sump

Weak headlamp aim patterns

Both rear tyre valves excessively perished

n/s/f wiper split

rear exhaust silencer rubber mounting deteriorating

Rear coil spring corroded (2.4.C.1b)

front exhaust bracket broken due to corrossion

rear exhaust silencer mounting rubber splitting advise replaceing

(5) Lower centre gearbox mounting deteriorated slightly.

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

(5) Lower centre gearbox mounting deteriorated slightly.

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Direction indicators slightly discoloured (1.4.A.2f)

coolant leak from radiator