2011 Citroen Relay

Front Exhaust has a minor leak of exhaust gases fixings deteriorating (6.1.2 (a))

Nearside Front Lower Suspension component ball joint has slight play found with pry bar (5.3.4 (a) (i))

Nearside Rear parking brake effort low

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

parking brake efficiency just met

Central Front exhaust leak

Central exhaust heat shield missing

Offside Rear light slight condensation

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Headlamp aim too high (4.1.2 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Parking brake inoperative on one side both low effort (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases pre cat (7.1.2)

Offside Front Body has a sharp edge caused by damage mirror (6.1.C.1)

Offside Side repeater not working (1.4.A.2c)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front Exhaust has a minor leak of exhaust gases pre cat (7.1.2)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake: efficiency below requirements (3.7.B.7)