2006 Toyota Aygo

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Hazard warning lamps inoperative (4.4.1 (e))

Nearside Rear Outer Vehicle structure inadequately repaired such that structural rigidity is significantly reduced sill (6.1.1 (d) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Outer Vehicle structure inadequately repaired such that structural rigidity is significantly reduced sill (6.1.1 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Play in steering rack inner joint(s) ()

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

o/s/r tyre perished

Nearside Rear Service brake excessively binding (1.2.1 (f))

o/s/r tyre perished

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

front antiroll bar drop link bushes slightly perrished

general corrosion to underbody

rear wiper blade split

front discs corroded

front to rear brake pipes corroded

rear wiper arm loose

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Indicator switch faulty (1.4.A.1)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front discs corroded

front to rear brake pipes corroded

rear wiper arm loose

Brake pipe slightly corroded (3.6.B.2c)

N/S/R tyre has slight damage to outside face

Nearside Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

O/S/F tyre worn on inside edge

Offside Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside front brake binding (3.7.B.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Exhaust has a minor leak of exhaust gases (7.1.2)

nearside front wheel bearing not checked

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

both front brake discs very worn on inner faces

cut in outer wall on offside front tyre

Nearside Outer Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)