2003 Toyota Land Cruiser

ALL SUSPENSION AND CHASSIS UNDERSEALED

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced CROSS BEAM/TORSION BAR MOUNTINGS (6.1.1 (c) (i))

General Underbody Corrosion

Nearside Drive shaft joint constant velocity boot slightly deteriorated

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Headlamp aim too low (4.1.2 (a))

Offside Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Vehicle structure slightly corroded within 30cm of towbar mounting rear crossmember (6.1.6 (i) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength corrosion to front chassis, less than 12"from anti roll bar mounting (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength corrosion to front chassis, less than 12"from anti roll bar mounting (5.3.6 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

engine cover fitted

undertray fitted

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material to front flexi (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to front flexi (1.1.11 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

corrosion to all body mounting areas

parts of the chassis and suspension are corroded in perscribed areas

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

slight binding on near side rear wheel

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

rear tyres balding on edges

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)