2006 Nissan Micra

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Rear Coil spring corroded both rear (5.3.1 (b) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Tyre slightly damaged/cracking or perishing ALL ROUND (5.2.3 (d) (ii))

Offside Front Outer Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

handbrake has a lot of travel

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge close to limit and perishing (5.2.3 (e))

Nearside Rear tyre poor condition and cracking to sidewall and tread

Oil leak

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Front position lamp(s) not working (1.1.A.3b)

passenger door cannot be opened from outside the vehicle boot (6.2.B.1c)

Nearside Rear tyre poor condition and cracking to sidewall and tread

Oil leak

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

(3.7A.5b)The calculated brake imbalance across Axle 1 has been recorded at 20%,indicating that the brakes are ready for service

(4.1D.1b)The offside front tyre outer wall is deteriorating

(4.1E.1)The offside front tyre breadth of tread is worn down to 2.0mm

(4.2A.1e)All road wheels have trims fitted

(8.2.3)The nearside front windscreen washers have 50%,which do not provide an adequate supply of fluid to clear the swept area of the windscreen

STATUTORY PROVISIONS & REGULATIONS SECTION 45 OF THE ROAD TRAFFIC ACT 1988 AS AMENDED

(3.7A.5b)The calculated brake imbalance across Axle 1 has been recorded at 20%,indicating that the brakes are ready for service

(4.1D.1b)The offside front tyre outer wall is deteriorating

(4.1E.1)The offside front tyre breadth of tread is worn down to 2.0mm

(4.2A.1e)All road wheels have trims fitted

(8.2.3)The nearside front windscreen washers have 50%,which do not provide an adequate supply of fluid to clear the swept area of the windscreen

Registration plate lamp not working (1.1.C.1d)

STATUTORY PROVISIONS & REGULATIONS SECTION 45 OF THE ROAD TRAFFIC ACT 1988 AS AMENDED

(3.7.2d)The front service brakes proportionality during their increasing mode are at 23%.

(3.7.2e)The front service brakes proportionality during their reducing mode are at 23%.

(4.1E.1)The nearside front tyre breadth of tread is worn down to 1.69mm

(4.1E.1)The offside front tyre at the inner side of the central band of tread is wearing unevenly

(4.1E.1)The offside front tyre breadth of tread is worn down to 1.65mm

(4.1E.1)The offside rear tyre breadth of tread is worn down to 1.71mm

(4.2A.1)All road wheels have trims fitted

(8.2.3)The nearside windscreen washers have 50% which do not provide enough liquid to clear the swept area of the windscreen

(8.3.1e)The Vehicle and Operator Services Agency recommend that any items fitted to the windscreen swept area or the interior mirror should not be fitted if they are likely to obscure the view of the road

NOTES FOR THE VEHICLE OWNER/PRESENTER

STATUTORY PROVISIONS & REGULATIONS SECTION 45 1988 AS AMENDED

The vehicle manufacturer from new has fitted in various locations protective covers,which are preventing a complete visual examination of some areas of the inspection.

(3.5.1f)The offside front brake pad(s) are wearing thin,see also section (3.7.2d)

(3.7.2d)The front service brakes efforts during their application are at 20%,it appears the brakes are ready for service.

(4.1E.1)The offside rear tyre sectional width is worn down to 2.0mm

(4.2A.1)All road wheels have trims fitted

(6.1.1)The cars front end has damage present indicating that the car has been involved in a low speed collision.

SECTION - 4 - TYRES AND ROAD WHEELS

SECTION - 6 - BODY,STRUCTURE AND GENERAL ITEMS

Centre Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

(2.6.2)The offside rear wheel bearings have slight free play/wear present,See also VT30 (2.6.1)

(3.5.1f)The offside front brake pad(s) are wearing thin,see also section (3.7.2d)

(3.7.2d)The front service brakes efforts during their application are at 20%,it appears the brakes are ready for service.

(4.1E.1)The offside rear tyre sectional width is worn down to 2.0mm

(4.2A.1)All road wheels have trims fitted

(6.1.1)The cars front end has damage present indicating that the car has been involved in a low speed collision.

SECTION - 2 - STEERING (INCLUDING SUSPENSION)

SECTION - 3 - BRAKES

SECTION - 4 - TYRES AND ROAD WHEELS

SECTION - 6 - BODY,STRUCTURE AND GENERAL ITEMS

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)