2006 Toyota Aygo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Brake pipe excessively corroded rear of front to rear (1.1.11 (c))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area is inadequately repaired outersill (5.3.6 (a) (i))

Offside Brake pipe excessively corroded rear of front to rear (1.1.11 (c))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Gearbox mounting defective

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area fractured to the extent that control of the vehicle is likely to be adversely affected Outer Sill (5.3.6 (a) (ii)) DANGEROUS

Offside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Gearbox mounting defective

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Central Upper Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Brake pipe excessively corroded both front too rear (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Items removed from driver's view prior to test

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Items removed from driver's view prior to test

Nearside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Items removed from driver's view prior to test

Front windscreen wiper blade deteriorated